Skid plates

Kartera aizsargs AL VW TRANSPORTER T5, T6, T6.1

Crankcase protection - front/protection of the engine, gearbox and reducer, OPA051ALU.
- For VW TRANSPORTER T5, T6, T6.1 (for all engines)
- Material: aluminum 6 mm thick.
It is installed on cars with the original factory bumper.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.

Stock: 0 pcs.

Ātrumkarbas aizsargs AUDI A4(B5), SKODA SUPERB, VW PASSAT B5

Gearbox protection, plastic.
Suitable for car models with automatic gearbox:
- AUDI A4 (B5), 1994-2001, petrol and diesel engines.
- SKODA SUPEB, 2001-2008, gasoline and diesel engines.
- VW PASSAT B5, 1996-2005, petrol and diesel engines.

Stock: 0 pcs.

Engine, gearbox and radiator protection MET NISSAN QASHQAI

Stock: 0 pcs.

Engine, gearbox and radiator protection MET NISSAN X-TRAIL T33

Stock: > 1 pcs.

Kartera aizsargs AL FORD RANGER

Crankcase guard - front part.
material aluminum-5 mm
Comes with everything necessary for installation.

Stock: > 1 pcs.

Engine, gearbox and radiator protection MET AUDI A 4,VW PASSAT (B5)

Stock: 0 pcs.

Ātrumkarbas aizsargs AUDI A 6/ A 7

Gearbox protection, plastic.
Suitable for car models:
- AUDI A6 C7, 2011-2015, petrol and diesel engines.
- AUDI A6 C7 Quattro Avant, 2011-2015, petrol and diesel engines.
-AUDI A7 Sportback, 2010-2015, petrol and diesel engines.

Stock: 0 pcs.

Engine, gearbox protection MET HYUNDAI STARIA

Stock: 0 pcs.

Kartera aizsargs CITROEN BERLINGO,OPEL COMBO,PEUGEOT RIFTER/PARTNER/3008/5008,TOYOTA PROACE CITY VER

Crankcase guard - the middle part of the engine cover.
Suitable for car models with petrol and diesel engines:
- Citroen BERLINGO III 2018 -
- Opel COMBO E 2018 -,
- Peugeot RIFTER 2018 -,
- Peugeot PARTNER III 2018 -,
- Peugeot 3008 II 2016 -,
- Peugeot 5008 II 2017 -,
- Toyota PROACE CITY VERSO 2020-

Stock: 0 pcs.

Kartera aizsargs CITROEN JUMPER, FIAT DUCATO, PEUGEOT BOXER

Crankcase guard - under the engine, set, a copy of the original.
Consists of 3 parts:
- middle part (RP150721),
- right side part (RP150715),
- left side part (RP150716).
Suitable for car models:
- CITROEN JUMPER II 2018 - 2021, diesel.
- FIAT DUCATO III 2018 - 2021, diesel.
- PEUGEOT BOXER II 2018 - 2021, diesel.
Crankcase protection effectively protects engine components from damage and extends their service life.
It is made of high quality HDPE material, which guarantees high mechanical and chemical resistance, as well as to temperature changes.

Stock: 0 pcs.

Kartera aizsargs CITROEN JUMPER, FIAT DUCATO, PEUGEOT BOXER

Crankcase guard - under the engine, middle part.
Suitable for car models:
- CITROEN JUMPER II 2018 - 2021, diesel.
- FIAT DUCATO III 2018 - 2021, diesel.
- PEUGEOT BOXER II 2018 - 2021, diesel.
Crankcase protection effectively protects engine components from damage and extends their service life.
It is made of high quality HDPE material, which guarantees high mechanical and chemical resistance, as well as to temperature changes.

Stock: 0 pcs.

Ātrumkārbas aizsargs AUDI A4/S4/A5/S5/Q5/RS 5

Crankcase guard - under the gearbox, a copy of the original.
Suitable for car models:
- AUDI A4 III B8 2007-2011, petrol, diesel.
- AUDI A4 III Allroad Quattro 2011-2015, universal, gasoline, diesel.
- AUDI S4 III B8 2008-2011, quattro, universal, petrol diesel.
- AUDI A5 I 2007 - 2011, gasoline, diesel.
- AUDI S5 I 2008-2011, Coupe, Sportback, petrol.
- AUDI Q5 I 2009 - 2012, Sportsback, 2.0 petrol, 2.0 diesel.
- AUDI RS5 I 2010 - 2016, Coupe, Sportback, petrol.

Stock: 0 pcs.

Kartera aizsargs AL FORD RANGER

Crankcase guard rear part
Protects the gearbox
material aluminum-5 mm
weight 12 kg
Comes with everything necessary for installation

Stock: > 1 pcs.

Kartera aizsargs AL Toyota Land Cruiser J95

Crankcase protection - to protect the gearbox, OPA075ALU.
- For Toyota Land Cruiser J90/J95, 1996-2002 (long version), for gasoline engines.
- Material: aluminum 6 mm thick.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.
The gear guard is only one part of the kit (OPAK019ALU/OPAK020ALU) but can be used without the need to mount other parts.
To install the gearbox protection on the short version of Toyota Land Cruiser J90, it is necessary to purchase a protective rail (OP062MET) in addition to it.

Stock: 0 pcs.

Kompozītmateriāla droseļvārsta aizsargs DACIA DUSTER

Engine protection. Made of composite material using the most modern technologies.
Ensures the safety of the engine and its units for any shocks.
Fully protects the engine compartment from moisture, salt, snow and dirt.
Unlike metal protections, it absorbs well the impact and at the same time does not receive residual plastic deformations (dents), which subsequently will inevitably lead to damage to the engine or its units.
Protection is attached only to the supporting elements - side members, front and rear beam.

Fastening elements of protection are also fuses. With a strong dynamic impact, exceeding the strength of the side members, the protection comes unfastened and remains on the obstacle, while protecting the entire bottom of the vehicle from above above the vehicle protection from damage. In this case, the protection itself in such cases is destroyed very rarely. As a rule, it is put back using new fastening elements.
These fasteners also perform another very important task - they ensure the requirements of passive safety according to the EURO NCAP norms. With a strong frontal impact protection is detachable and allows the engine to freely go under the vehicle interior.

Stock: 0 pcs.

Kartera aizsargs AL Toyota Land Cruiser J90/J95

Crankcase protection - to protect the gearbox OPA074ALU.
- For Toyota Land Cruiser J90/J95, 1996-2002 (for petrol engines).
- Material: aluminum 6 mm thick.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.
The crankcase guard is only one part of the set (OPAK019ALU/OPAK020ALU) , but it can be used without the need to install other parts.

Stock: 0 pcs.

Kartera aizsargs AL Toyota Land Cruiser J90/J95

Crankcase protection - to reducer protect OPA015ALU.
- For Toyota Land Cruiser J95, 1996-2002(long versions), for diesel engines.
- Material: aluminum 6 mm thick.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.
The crankcase guard is only one part of the set(OPAK003ALU/OPAK013ALU) , but it can be used without the need to install other parts.
To install the gearbox protection on the short version of Toyota Land Cruiser J90, it is necessary to purchase a protective rail (OP062MET) in addition to it.

Stock: 0 pcs.

Kartera aizsargs AL Toyota Land Cruiser J90/J95

Crankcase protection - to protect the gearbox OPA014ALU.
- For Toyota Land Cruiser J90/J95, 1996-2002 (for diesel engines).
- Material: aluminum 6 mm thick.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.
The crankcase guard is only one part of the set(OPAK003ALU/OPAK013ALU) , but it can be used without the need to install other parts.

Stock: 0 pcs.

Kartera aizsargs AL Toyota Land Cruiser J90/J95

Crankcase protection - front / protection of the engine crankcase, axle and clutch rod OPA013ALU.
- For Toyota Land Cruiser J90/J95, 1996-2002 (for all engine versions).
- Material: aluminum 6 mm thick.
Installed on cars with original factory bumper.
The set of screws required for installation is supplied in the kit, installation is carried out in the original mountings on the car frame.
The crankcase guard is only one part of the set(OPAK003ALU/OPAK013ALU/OPAK019ALU/OPAK020ALU) , but it can be used without the need to install other parts.

Stock: 0 pcs.

Kartera aizsargs AL TOYOTA LAND CRUISER 90

Set of crankcase protection for Toyota Land Cruiser J90, 1996-2002(lshort base), petrol.
Material - aluminum, 6 mm thick.
The kit consists of:
- front crankcase protection (OPA013ALU).
- transmission protection (OPA074ALU).
- gear cover protection (OPA075ALU).
- reducer cover beam (OP062MET).
A set of mounting screws is supplied with the guards, and the installation is carried out in the original mountings on the car frame.

Stock: 0 pcs.